The stainless steel plate Water Tank adopts to the import food level SUS304,SUS316 stainless steel plate, blocking-up the sunlight irradiation thoroughly, does not multiply the algae, at any time maintains the water quality is clean.It can eradicate the second pollution completely. The stainless steel plate has light weight and high strength. The yield strength of stainless steel is equivalent to 1.5 times that of carbon steel and 6 times that of GRP. Compared with the SMC water tank, the Stainless Steel Water Tank has the better high temperature resistant performance. So it can apply to the request of fire and building standard act completely. Stainless Steel Water Tank adopts to the all welding assembly. Compared with the traditional water tank which connection by bolt, it get rid of the sealing strip and bolt to make the water tank more strength and never leakage.
Stainless Steel Water Tank Stainless Steel Water Tank,Stainless Steel Tank,Steel Water Tank,Stainless Water Tank Shandong Hiking International Commerce Group Co.,Ltd , https://www.hikingfrp.com
Do not think that all wells can use QJ-type wells with submersible pumps to achieve water needs, I do not know it is also conditional. Today, Xiao Bian talked about the use of submersible pumps QJ type wells for everyone to understand, we can not blindly use the conditions not allowed. The following mainly from the three aspects to illustrate the specific contents are as follows: QJ-type submersible pump with the use of requirements 1, QJ-type submersible pump power requirements: (1) centrifugal pump rated frequency of 50 Hz, the motor rated voltage should be guaranteed 380 + 5% volts three-phase AC power supply (if the user voltage is 660 volts special ordering required). (2) Transformer load power should not exceed 75% of its capacity. (3) When the transformer is farther away from the well, the voltage drop of the transmission line should be taken into consideration. For the motor with the power larger than 45KW, the distance between the transformer and the wellhead should not exceed 20m. If the transformer is larger than 20m, Level, and consider the line voltage drop. 2, QJ wells with submersible pump water quality requirements: (1) generally non-corrosive water. (2) sand content in water is not more than 0.01% (mass ratio). (3) PH value in the range of 6.5-8.5 pH. (4) chloride content in water is not greater than 400 mg / l. (5) Hydrogen sulfide content of not more than 1.5 mg / l. (6) water temperature is not higher than 20 ℃. 3, QJ-type wells with submersible pump wellbore requirements: integrity, smooth, not protruding or well pipe dislocation phenomenon, well diameter not less than the corresponding frame size. The above is the QJ-type submersible pump with the relevant requirements of the introduction, in the power, water quality, wellbore and other aspects of the proposed requirements. Therefore, not all wells can use this type of pump products, users should consider these factors in the selection, good to make a judgment. Expand to read: Pumps Valves Tube Fittings Exhibition Water Expo Xiamen Maritime Exhibition Internet + Forum Yiwu Fair Mold Top Ten Brands 2016 Exhibition Information This article belongs to Industrial Internet (Xiamen) Technology Co., Ltd. All are welcome to reprint, please note Ming author and source of: Asian pumps network editor: small L (QQ / micro-channel:) starting: http: //beng.liuti.cn/ (service hotline:)